Top Arm Update

First pair of top arms have been welded, not bad, they have twisted very slightly and sprung in about 20 thou. The tube for the top ball joint has also distorted slightly making the adjusters a tight fit. I expected to have to make a couple of tweaks to perfect the design, this first set will be used to check for clearance issues with the front upright and to make sure I can get enough camber adjustment with no lower shims fitted.

To address some of the issues, the next arms will be made using the jig removed from its back plate so that a number of tack welds can be put in place on both sides to prevent distortion (springing). I'm also going to use slightly thicker tubing and then ream to the correct size.